| Page 4 - Index - Page 6 |
|
Chrysler Three and Four Cylinder Engines Using Separate Switch Boxes and Ignition Coils (Continued)
|
NO FIRE OR INTERMITTENT ON ONE CYLINDER:
- Check stator and trigger resistance, trigger wire sets read approximately 50 ohms between the wire sets (DVA-5V or more), stator reads 680-800 ohms, DVA 180V or more from blue to yellow.
- If readings are good, disconnect kill wire from one pack. If the dead cylinder starts firing, the problem is likely the blocking diode in the other pack.
|
NO FIRE ON TWO CYLINDERS:
- If two cylinders from the same CD unit will not fire, the problem is usually in the stator. Test per above.
|
ENGINE WILL NOT KILL:
- Check kill Circuit in the pack by using a jumper wire connected to the kill wire coming out of the pack and shorting it to ground. If this kills the pack, the kill circuit in the harness or on the boat is bad, possibly the ignition switch.
|
COILS ONLY FIRE WITH THE SPARK PLUGS OUT:
- Check for dragging starter or low battery causing slow cranking speed. DVA test stator and trigger.
|
HIGH SPEED MISS:
- Check stator DVA voltage to each pack at high speed. If it exceeds 400 volts, replace the pack.
- Disconnect the rectifier. If the engine fires smoothly, replace the rectifier.
|
| Ignition Component Wire Connections: 2 & 3 cylinder |
Pack #1 - fires #1 and #2 cylinder
|
|
Trigger: |
Orange
Green
Orange
Green |
To Pack #1: |
Orange
Green
Red
White/green stripe
|
|
Stator: |
Yellow
Blue
|
To Pack #1: |
Yellow
Blue
|
Coil #1
Coil #2 |
White
White
|
To Pack #1:
To Pack #1: |
Orange
Red
|
Pack #2 - fires #3 cylinder
|
|
Trigger: |
Red
White/Green stripe
|
To Pack #2: |
Red
White/Green stripe
|
|
Stator: |
Yellow
Blue
|
To Pack #2: |
Yellow
Blue & Brown/Blue stripe pack #1
|
|
Coil #3 |
White
|
To Pack #2: |
Red
|
Ignition Component Wire Connections: 4 cylinder |
Pack #1 - fires #1 and #2 cylinder
|
|
Trigger: |
Orange
Green
Red
White/Green Stripe |
To Pack #1: |
Orange
Green
Red
White/Green Stripe
|
|
Stator: |
Yellow
Blue
|
To Pack #1: |
Yellow
Blue
|
Coil #1
Coil #2 |
White
White
|
To Pack #1:
To Pack #1: |
Orange
Red
|
Pack #2 - fires #3 and #4 cylinder
|
|
Trigger: |
Orange
Green
Red
White/Green stripe
|
To Pack #2: |
Orange Stripe
Green
Red
White/Green stripe
|
|
Stator: |
Yellow
Blue
|
To Pack #2: |
Yellow
Blue
|
|
Coil #3 |
White
|
To Pack #2: |
Orange
|
|
Coil #4 |
White
|
To Pack #2: |
Red
|
....end of Chrysler Ignition Troubleshooting Section.
|
| Page 4 - Index - Page 6 - |
